Rear Lid Emblem

Rear Lid Emblem





• Outer edges of rear lid are used as reference edges.

Installation

- Warm vehicle and type designation to room temperature.

- Bonding surfaces must be dry and free from dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

- Pull off backing paper and press on characters - 1 -, maintaining pressure for approximately 3 seconds.

- Press the name plates one more time using a roller after installing them.

• a = 22 mm measured from the curve.

• b = 81mm.

• c = 172 mm

• d = 179mm.

• e = 90 mm

• f = 4 mm

S8





• a = 69 mm

• b = 73 mm