Bucket Seat

Connectors, Disconnecting

Procedure






- Loosen seat mounting bolts. Refer to => [ Seat ] Seat.

- Tip front seat back.

- Release cover cap - 1 - in direction of - arrow -.

- Remove wiring bracket - 3 -.






- Release clip in direction of - arrow - with a small screwdriver and disconnect electrical connector - 1 - with side airbag terminal resistance.

• The side airbag terminal resistance is a separate connector housing without a cable. The side airbag cable, as shown in the illustration above, is not in the TT.

- Press in tab on connector for heated seat - 2 - on tunnel side and disconnect connector for heated seat.

For vehicles with seat belt fasten sensor:

- Press in tab on connector for seat belt fasten sensor on tunnel side and disconnect connector for seat belt fasten sensor.