Backrest Cover

Backrest Cover

Special tools, testers and auxiliary items required

• Pry lever (80 - 200)











1 Right backrest cover

• Removing and Installing, refer to => [ Backrest Cover, Removing and Installing ]

2 Left backrest cover

• Removing and Installing, refer to => [ Backrest Cover, Removing and Installing ]

3 Retaining clip

4 Bolt

• Tightening specification 2.5 Nm

• Replace with locking compound

• Locking compound, refer to Parts Catalog

5 Seat belt guide outer part

• Removing and Installing, refer to => [ Seat Belt Guide Outer Part, Removing and Installing ]

6 Seat belt guide inner part

• With release lever

• the version without the backrest release is shown in the illustration

• To remove, remove backrest cover. Refer to => [ Backrest Cover and Upholstery ] Backrest Cover and Upholstery

• Disassembling => [ Rotate inner part of belt guide and release retaining tabs. ] Backrest Lock Actuating Link

7 Backrest frame

Backrest Cover, Removing and Installing





- Affix backrest panel all around trim - 1 - using adhesive tape - 2 -.

- Using pry lever (80-200) , pry off upper backrest cover at inner side, starting from backrest panel.

- Disengage clip at front corner of backrest panel extremely carefully.

Seat Belt Guide Outer Part, Removing and Installing





- Carefully guide the pry lever (80-200) between the backrest cover and belt guide outer part.

- Carefully press to disengage outer part of belt guide from inner part of belt guide.