Lumbar Support Adjustment Switches E176 and E177

Lumbar Support Adjustment Switches E176 and E177

Removing






- Remove sill side trim - 1 -. Refer to => [ Sill Side Trim ] Sill Side Trim.

- Disconnect the connector - 4 -.

- Remove bolts - 2 - (quantity: 2).

- Remove driver seal lumbar support adjustment switch (E176) - 3 - or front passenger seat lumbar support adjustment switch (E177) from sill side trim - 1 -.

Installation






Install in reverse order of removal. Note the following:

- Route wires as close to the coupling - 4 - as possible.

For the correct tightening specifications, refer to => [ Lumbar Support Adjustment Switches E176 and E177 Assembly Overview ] Lumbar Support Adjustment Switches E176 and E177 Assembly Overview