Body Emblem

Lettering

• The adhesive surfaces on the body must be free of dirt and grease.

• Clean the adhesive surfaces using cleaning solution (D 009 401 04).

• Warm the adhesive surfaces and lettering to approximately 104°F (40°C) using a hot air blower.

• After assembly, press the lettering with the (T10314).

Special tools, testers and auxiliary items required

• Roller (T10314)

• Hot air gun (V.A.G 1416)

Rear Lid Dimensions






• Dimension - a - = 33 mm

• Dimension - b - = 22 mm

• Dimension - c - = 27 mm

• Dimension - d - = 27 mm

• Dimension - e - = 17.5 mm

• Dimension - e - = 22 mm

• Dimension - f - = 4 mm

Fender Dimensions






- Pull off the protective film - arrow - prior to installation.

• Dimension - a - = 41mm

• Dimension - b - = 42 mm

• Dimension - c - = 34 mm