Subframe, Lower Transverse Link, Upper Transverse Link, Tie Rod, Level Control System Sensor, Assembly Overview

Subframe, lower transverse link, upper transverse link, tie rod, level control system sensor (all wheel drive) - Coupe, assembly overview





1. Eccentric bolt
^ After loosening, perform vehicle alignment
^ Do not turn more than 90 degrees left or right (that is, smallest to largest possible adjustment)
2. Nut
^ 95 Nm
^ Always replace after removal
^ Always tighten bolts in curb weight position
3. Eccentric washer
^ Inner bore with tab
4. Eccentric bolt
^ After loosening, perform vehicle alignment
^ Do not turn more than 90 degrees left or right (that is, smallest to largest possible adjustment)
5. Eccentric washer
^ Inner bore with tab
6. Nut
^ 95 Nm
^ Always replace after removal
^ Always tighten bolts in curb weight position

Note:
^ Adjust torque wrench V.A.G 1332 to 80 Nm when tightening nut.
^ This torque specification applies only in conjunction with Insert Tool T10179.

7. Subframe
8. Bolt
^ 90 Nm plus an additional 1/4 turn (90 degrees)
^ Always replace after removal
9. Lower transverse link
10. Bolt
^ Always replace after removal
11. Nut
^ 90 Nm plus an additional 1/4 turn (90 degrees)
^ Always replace after removal
^ Always tighten bolts in curb weight position
12. Left Rear Level Control System Sensor G76 and Right Rear Level Control
^ System Sensor G77
13. Bolt
^ 5 Nm
14. Upper control arm
15. Washer
16. Bolt
^ 130 Nm plus an additional 1/4 turn (90 degrees)
^ Always replace after removal
^ Always tighten bolts in curb weight position
17. Nut
^ Always replace after removal
18. Wheel bearing housing
19. Washer
20. Nut
^ Always replace after removal
21. Washer
22. Washer
23. Bolt
^ 130 Nm plus an additional 1/4 turn (90 degrees)
^ Always replace after removal
^ Always tighten bolts in curb weight position
24. Tie rod
^ Closed in direction of travel
25. Cross member
26. Bolt
27. Nut
^ 90 Nm plus an additional 1/4 turn (90 degrees)
^ Always replace after removal
^ Always tighten bolts in curb weight position
28. Bolt
^ 5 Nm
29. Bolt
^ Always replace after removal
30. Bolt
^ 50 Nm plus an additional 1/2 turn (180 degrees)
^ Always replace after removal