Backrest Cover and Upholstery
Backrest Cover and Upholstery
1 Backrest cover
Removing
- Remove the seat. Refer to => [ Seat ] Seat.
- Remove the backrest. Refer to => [ Front Backrest and Seat Pan ] Front Backrest and Seat Pan.
- Remove both outer parts of the belt guide - 2 - => [ Seat Belt Guide Outer Part, Removing and Installing ] Backrest Cover.
- Pry out cover on belt guide, drill out pop rivet with a 5.0 mm drill bit and remove belt guide => [ Seat Belt Guide, Removing and Installing ].
- Pry grip channel at edge of backrest cover - 1 - all around out of guide at backrest - 7 - => [ Pry grip channel for backrest cover out of guide ].
- in bending sections, grip channel is also secured using clips - 3 -, carefully remove clips.
- Carefully loosen seams of backrest cover from Velcro fastener at backrest cushion - 4 -.
- Disengage lower retaining strip at foam block - 6 -.
- Remove backrest cover.
Installation
Install in reverse order of removal.
2 Seat belt guide outer part
• Removing and Installing, refer to => [ Seat Belt Guide Outer Part, Removing and Installing ] Backrest Cover
3 Clips (quantity: 8)
• For grip channel of backrest cover
• Install in bend in backrest
4 Backrest padding
Removing
- Remove backrest cover - 1 -.
- Remove backrest cushion from backrest.
Installation
Install in reverse order of removal.
5 Felt mat
• Glued
6 Foam block
Removing
- Remove backrest cover - 1 -.
- Remove backrest cushion - 4 -.
- Carefully loosen foam block bonding from backrest.
- Tip foam block forward at upper edge.
- Remove foam block.
Installation
Install in reverse order of removal.
- If necessary, replace double adhesive tape. Refer to Parts Catalog.
7 Backrest
• Removing and Installing, refer to => [ Front Backrest and Seat Pan ] Front Backrest and Seat Pan
8 Belt guide
• Removing and Installing, refer to => [ Seat Belt Guide, Removing and Installing ]
9 Trim
• For belt guide
• Removing and Installing, refer to => [ Seat Belt Guide, Removing and Installing ]
10 Pop rivet
Seat Belt Guide, Removing and Installing
- Pry out trim - 1 - with Pry Lever (80 - 200) at outer corner - arrow A -.
- Remove trim downward - arrow B -.
- Drill out pop rivets - arrows - with a 5.0 mm drill bit.
- Remove belt guide - 1 - from backrest frame.
Pry grip channel for backrest cover out of guide
- Starting at bottom, pry grip channel for backrest cover out of guide at backrest, using for example, an awl - arrow -; lightly press together backrest upholstery in order to release backrest cover.