Evaporative Emission Control Canister

EVAP Canister and Leak Detection System, Hose Diagram






1 Vacuum Line

• From the engine to the leak detection pump (V144)

• Clipped into the bracket on the underbody

2 Vent Line

• From the EVAP canister to Evaporative Emission (EVAP) canister purge regulator valve 1 (N80)

• Clipped to fuel tank in fuel tank area

• Separating points at front and rear on fuel tank

3 Fuel Filler Tube

4 Vent Line

• From fuel filler tube to EVAP canister

• Clipped into the bracket on the underbody

5 EVAP Canister

• Installed location: In the bottom of the spare wheel well

• Removing and Installing, refer to => [ Evaporative Emission (EVAP) Canister ] Evaporative Emission (EVAP) Canister

6 Connecting Line

• From the leak detection pump to the EVAP canister

• Clipped into the bracket on the underbody

7 Air Filter Housing

• For the leak detection pump

8 Leak Detection Pump (V144)

• Installed location: Under wheel housing liner in left rear wheel housing

• Checking: In "Guided Fault Finding" using the vehicle diagnostic tester

• Removing and Installing, refer to => [ Leak Detection Pump (LDP) (V144) ] Service and Repair

9 Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 (N80)

• Installed location: At front in engine compartment

10 Vacuum hose to Leak Detection Pump

• To disconnect, press release button on connection piece

11 Vacuum hose to EVAP Canister

• To disconnect, press release button on connection piece