Ribbed Belt

Ribbed Belt

Special tools, testers and auxiliary items required

• Locking Pin (T10060 A)

Removing

- Pull the EVAP canister in the engine compartment together with the connected hoses upward out of the bracket - arrow - and lay it to the side.





Risk of destroying due to reversed running direction on a used ribbed belt.

• Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

- To release ribbed belt tension, rotate tensioner in direction of - arrow -.





- Secure tensioner with (T10060 A).

- Remove ribbed belt.

Installing

Installation is in reverse order of removal, note the following:

• Before installing ribbed belt, generator, A/C compressor must be securely installed.

- Route ribbed belt as follows:





1. Idler roller

2. Vibration damper

3. Coolant pump

4. Tensioning roller

5. Generator

6. Idler roller

7. A/C Compressor

- Hold tensioner with open end wrench and remove (T10060 A).





- Release tensioner.

- Check whether ribbed belt is routed correctly.

- Start engine and check whether ribbed belt runs correctly.