Clutch Housing, Servicing

Clutch Housing, Servicing

Special tools, testers and auxiliary items required

• Punch (VW 407)

• Sleeve (30 - 21)

• Drift (T10168)

• Thrust Piece (T40008)

• - 1 - Kukko 21/2 Internal puller and Kukko 21/4

• - 4 - Kukko support 22/1 and 22/2

Pulling Out Bearing Bushing for Selector Rod





A Support, for example (Kukko 22/1)
B Internal puller 14.5 to 18.5 mm, for example (Kukko 21/2)

Driving In Bushing for Selector Rod

- Drive in bushing up to the stop when tool makes contact





Pull Needle Bearing Off Clutch Housing





A Support, for example (Kukko 22/2)
B Internal puller 23.5 to 30 mm, for example (Kukko 21/4)

• Needle bearing is destroyed when it is removed and must be replaced.

Pressing In Needle Bearing into Clutch Housing

- During pressing sequence, place thrust washer - B - for reverse shaft onto the needle bearing - A -.





Press Axle for Reverse Gear Shift Fork into Clutch Housing