Defroster Door Motor (V107)

Defroster Door Motor (V107)

with Defroster Door Motor Position Sensor (G135)

• You can check the adjustment motor's function via the "output diagnostic test mode" using Vehicle diagnosis, testing and information system (VAS5051B) in the "Guided Fault Finding" function or check it without a tester as follows: if not using a tester, connect both contacts 5 and 6 on the adjustment motor's connector to a 12 volt DC source. The adjustment motor will move in one direction up until the stop, and will reverse direction if the plus and minus contacts are switched. Use an adapter cable. Refer to => [ Adapter Cable for Activating Control Motors ] Adapter Cable for Activating Control Motors.

• Perform a basic setting on the A/C after installing a new motor. Refer to Vehicle diagnosis, testing and information system (VAS5051B) in the "Guided Fault Finding" function.

• Use "output diagnostic test mode" and "basic setting" to test the activation of A/C electrical components, if necessary (for example, allocation test) using Vehicle diagnosis, testing and information system (VAS5051B) in the "Guided Fault Finding" function.

• This motor is fastened on the right on air distributor housing in vehicles with right-side steering.

Removing

- Remove the complete instrument panel and instrument panel cross-member.

- Remove left footwell vent - A - (driver side).






- Remove Data bus on board diagnostic interface (J533) (secured to bracket - A - in area of steering column).






- Remove bracket - A -.

- Mark connector - C - to Defroster Door Motor (V107) (danger of interchange with other connectors of same construction).






- Disconnect connector - C - from defroster door motor.

- Remove bolts - A -.

- Remove control motor - B -.

- Loosen lever - E - on defroster door motor from the connecting rod - D -.

Installing

• Lever - E - on control motor and connecting rod - D - are color-coded, they are colored blue for defroster door motor.






Reinstall all removed components in the opposite sequence while observing the following:

- Install the wiring harness so that it cannot come in contact with any moving parts (e.g. the actuating arm of the control motor).

- Check Climatronic control module (J255) DTC memory and erase any possible displayed malfunctions using Vehicle diagnosis, testing and information system (VAS5051B) in the "Guided Fault Finding" function.

- Perform a basic setting and output diagnostic test on the A/C and check the DTC memory one more time. Refer to Vehicle diagnosis, testing and information system (VAS5051B) in the "Guided Fault Finding" function.