Wind Deflector or Mount

Wind Deflector or Mount

Removing

- Remove rear bulkhead cover. Refer to => [ Rear Bulkhead Cover ] Rear Bulkhead Cover.

- Remove left and right linkage removal flaps.

- Remove front convertible top compartment trim. Refer to => [ Front Convertible Top Compartment Trim ] Front Convertible Top Compartment Trim.

Vehicles with Wind Deflector

- Disconnect connector on wind deflector motor and unclip electrical wire on deflector.

Vehicles with Electrical Convertible Top

- Unclip hydraulic lines from wind deflector or deflector support (5 clips).

Procedure for all Vehicles

- Remove bolts - 1 - on both sides of vehicle. Be careful of the washers => [ (Item 3) Washer ] Wind Deflector Assembly Overview.






- Remove wind deflector - 2 - or support upward.

Installation

Install in reverse order of removal. Note the following:

- Insert wind deflector - 2 - or support with locking pins - arrow - (on left and right sides of vehicle) in holes in body.

- Make sure there is a washer => [ (Item 3) Washer ] Wind Deflector Assembly Overview between the bolt - 1 - and the insulation - 3 -.

For the correct tightening specifications, refer to => [ Wind Deflector Assembly Overview ] Wind Deflector Assembly Overview