Seat

Seat

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1332)






• The bucket seat does not have a side airbag. The side airbag electrical connector must have a terminal resistance in the vehicle wiring harness.

• The terminal resistance is a separate connector housing. Refer to => [ Connectors, Disconnecting ] Connectors, Disconnecting.






1 Front seat

Removing

- Push front seat - 1 - fully upward and to the rear.

- Remove front bolts - 3 - (quantity: 2).

- Move seat forward.

- Remove rear bolts - 4 - (quantity: 2).

- Tip front seat - 1 - back.

- Disconnect electrical harness connectors. Refer to => [ Connectors, Disconnecting ] Connectors, Disconnecting.

- Remove seat.

Installation

Install in reverse order of removal.

2 Seat rail covers

• Removing and Installing, refer to => [ Seat Rail Covers ] Seat Rail Covers

3 Front bolts

• Quantity: 2

• Tightening specification 50 Nm

4 Rear bolts

• Quantity: 2

• Tightening specification 50 Nm

5 Seat Forward/Back Adjustment Stop

• Quantity: 2

• Clipped

• Removing and Installing, refer to => [ Seat Forward/Back Adjustment Stop ] Seat Forward/Back Adjustment Stop