Upper Transverse Link

Upper Transverse Link

Special tools, testers and auxiliary items required

• Torque Wrench 40-200 Nm (V.A.G 1332)

Removing

- Measure dimension from center of wheel to lower edge of wheel housing. Refer to => [ Wheel Bearing, Lifting To Curb Weight Position ] Rear Suspension.

- Remove the wheel.

- Remove the coil spring. Refer to => [ Coil Spring ] Coil Spring.

- Completely disengage wire - 1 - from bracket - 2 -.






- Remove nut - 6 - and washer - 5 -.

- Remove the bolt - 3 - and washer - 4 -.

- Mark, e.g. using a felt-tip marker, position of eccentric bolt - arrow - to subframe.






- Remove the bolt - arrow -.

- Remove upper transverse link.

Installing

Install in reverse order of removal. Note the following:

- Install bolt - 3 - with washer - 4 -.






Transverse link connections may only be carried out of dimension between wheel hub center and lower edge of wheel housing, measured before assembly, is achieved => [ Wheel Bearing, Lifting To Curb Weight Position ] Rear Suspension.

- Note applied marking of eccentric bolt - arrow - to subframe.






Tightening specifications, refer to => [ Subframe, Lower Transverse Link, Upper Transverse Link, Tie Rod, Level Control System Sensor Overview ] Subframe, Lower Transverse Link, Upper Transverse Link, Tie Rod, Level Control System Sensor Overview

Tightening specifications, refer to => [ Subframe, Diagonal Braces, Crossmember, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview ] Subframe, Diagonal Braces, Crossmember, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview

Tightening specifications, refer to => [ Wheel Bearing Housing, Wheel Bearing Unit, Trailing Arm with Bracket and Stone Chip Protection Overview ] Wheel Bearing Housing, Wheel Bearing Unit, Trailing Arm With Bracket and Stone Chip Protection Overview

Tightening specifications, refer to => [ Shock Absorber and Coil Spring Overview ] Shock Absorber and Coil Spring Overview

Tightening specifications, refer to => [ Stabilizer Bar Overview ] Stabilizer Bar Overview

•

- An axle alignment is necessary. Refer to the table => [ An Axle Alignment is Necessary When: ] An Axle Alignment is Necessary When: