Rearview Mirror

Rearview Mirror






1 - Mirror Housing

• May be removed from door without removing entire exterior rearview mirror, refer to => [ Mirror Housing ] Mirror Housing.

2 - Adjusting Motor

• Removal, refer to => [ Mirror Adjusting Motor ] Mirror Adjusting Motor

3 - Mirror Adjusting Unit

• Before replacing, window frame must be removed, refer to => [ Window Frame and Window Regulator ] Window Frame and Window Regulator.

• Before removing, remove exterior rearview mirror from door

• To remove, pry off mirror lens, disconnect electrical harness connectors for mirror heater, remove Phillips head screws - 6 - and remove mirror adjusting unit from mirror housing - 1 -.

4 - Mirror Glass

• Use special tool 80-200 (pry lever) to unclip.

• Protect mirror housing against damage using textile tape above and below.

• Press mirror lens first downward, then upward.

• To install mirror lens into guide pins and friction finger, insert into friction spring and press on.

• Apply pressure only on center of glass, wear protective gloves while doing so.

5 - Harness Connector For Mirror Heater

6 - Electrical Connection

• Only for automatic day/night exterior rearview mirror.

• Clip in clips - arrows - on inside of mirror.

7 - Electrical Connection

• Clipped in on window frame at bottom.

8 - Combination Screw

• 12 Nm

9 - Front Door

10 - Seal

• Ensure correct seating when installing.

11 - Mirror Base

• Supplied with mirror adjusting unit delivery casing.

• Before removing, window frame must be removed.