Accessory Assembly Bracket

Accessory Assembly Bracket

Removing

- Drain coolant. Refer to => [ Cooling System, Draining and Filling ] Cooling System.

- Remove ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.

- Remove generator.

- Disconnect solenoid clutch electrical connector - 1 - on A/C compressor.






Risk of injury from refrigerant.

• The air conditioning refrigerant circuit must not be opened.

- Remove A/C compressor bolts - arrows -.


Risk of damaging coolant lines and hoses.

• Do not stretch, kink or bend coolant lines and hoses.

- Tie up the compressor with the refrigerant lines attached to the longitudinal member.

- Remove the bolt - arrow - for the oil dipstick guide tube.





- Remove the bolts - 1 through 5 - and pull off the accessory assembly bracket from the coolant pump housing.

Installing

• Tightening specifications, refer to => [ Ribbed Belt Drive Assembly Overview ] Cooling System.

Installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to an additional torque.

• Replace the O-rings and seals.

- Coat the O-rings - 4 - with coolant additive.





- Install the connection - 2 - in the coolant pump housing - 3 -.

- Press the accessory assembly bracket - 1 - onto the connection, mount the bolts and tighten.

- Install A/C compressor.

- Install generator.

- Install ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.

- Fill with coolant => [ Filling ] Cooling System.