Exhaust System Component Overview

Exhaust System Component Overview






1 Bracket

• For exhaust system

2 Retaining Loop

• Replace if damaged

3 23 Nm

4 Center Muffler

• Unit with rear muffler

• Install exhaust system free of stress, refer to => [ Exhaust System, Installing ] Exhaust System, Installing

5 Retaining Loop

• Replace if damaged

6 23 Nm

7 Bracket for Exhaust System

8 25 Nm

9 Suspended Mount

• Replace if damaged

10 40 Nm

• Replace

11 Seals

• Replace

12 Front Exhaust Pipe Support

13 25 Nm

14 40 Nm

15 Oxygen Sensor Before Catalytic Converter

• 2 pieces

• The threads of new oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body

• When re-using the old oxygen sensor, grease the threads with hot bolt paste; the paste must not get into slots of oxygen sensor body; hot bolt paste

16 Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC)

• 2 pieces

• The threads of new oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body

• When re-using the old oxygen sensor, grease the threads with hot bolt paste; the paste must not get into slots of oxygen sensor body; hot bolt paste.

17 Front Exhaust Pipe With Catalytic Converters and Front Muffler

• Do not bend the flex joint more than 30° or it will get damaged.

• Do not load decoupling element on cable

• Do not damage wire mesh at decoupling element

• Protect catalytic converter from shocks and impact stress

• Removal and installation, refer to => [ Front Exhaust Pipe with Catalytic Converters and Front Muffler ] Service and Repair

• Remove decoupling element guard on replacement part as late as possible

• Install exhaust system free of stress, refer to => [ Exhaust System, Installing ] Exhaust System, Installing

18 Clamping Sleeve

• Before tightening, ensure exhaust system is tension-free, refer to => [ Exhaust System, Installing ] Exhaust System, Installing

• Installed location => [ Clamping Sleeve Location ]

• Tighten bolts evenly

19 40 Nm

• Replace

20 23 Nm

21 Suspended Mount

• Replace if damaged

22 Rear Muffler

• Unit with center muffler

• Install exhaust system free of stress, refer to => [ Exhaust System, Installing ] Exhaust System, Installing

23 Retaining Loop

• Replace if damaged

24 23 Nm

25 Bracket for Exhaust System

Clamping Sleeve Location





- Install clamping sleeve horizontally.

• Threaded connection points toward the right.