Navigation System II-D

Navigation System II-D

CAUTION!
Disconnect battery ground wire before working on electrical system.

On vehicles with Telematics, activate Telephone/Telematics Control Module (J526) service mode before disconnecting Battery (A) => [ Telematics Service Mode, Activating/Deactivating ] Procedures.

If the Battery (A) is reconnected, follow the procedure for disconnecting and connecting the Battery (A) Deactivate Telephone/Telematics Control Module (J526) service mode => [ Telematics Service Mode, Activating/Deactivating ] Procedures.

Description

The Radio Navigation System (RNS) combines the functions of a navigation system with those of a vehicle radio.

The system consists of:

• Radio receiver part

• 5-inch color display

• Navigation system with angular acceleration sensor

• CD drive for navigation system

• Navigation System Antenna (R50) connection

• Antenna Selection Control Module (J515)/Left Antenna Module (R108) connection

Enhancements:

• CD Changer (R41) connection

• Navigation/TV Tuner (J415) connection

Notes

Additional information => Navigation system plus operating instructions.

For CD preparation, the CD changer (R41) wiring harness is already installed in the vehicle. The connecting wire can only be used with genuine Audi CD-changers (R41).

Diagnosis is performed using "Guided Fault-Finding".

Repairs on antenna wires => Electrical Equipment - General

Information 97 Removal and Installation.

Repair to CAN bus lines => Electrical Equipment - General

Information 97 Removal and Installation.