Protective Moldings

Protective Moldings

• Protective moldings cannot be removed without destroying them.

- To remove, warm protective strips - 1 -, - 2 - or - 3 - with a hot air gun and remove.





• Adhesion surface must be free of dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

• Protective moldings must be attached only at room temperature.

• For this purpose, bring vehicle and protective moldings to room temperature at least 2 hours before processing.

• Protective moldings must be adhered within 90 minutes after protective foil has been removed.

- Pull protective foil - 4 - from double-sided adhesive tape - 5 - shortly before installation.

- Apply protective molding to be adhered at front and adhere working toward rear.

- Heat protective molding to approx. 40 °C using heat gun and forcefully press on or roll on.

• After adhering strip, leave vehicle 4 hours in room temperature.