Operation CHARM: Car repair manuals for everyone.

Clean Working Conditions






Clean Working Conditions

Fuel injection system/fuel system

Even minor contaminations can lead to malfunctions in the fuel injection system. When working on fuel supply/fuel injection system, observe the following rules of cleanliness:

Before loosening, connections and surrounding areas must be cleaned thoroughly with engine or brake cleaner, and then cleaned area must be dried completely.

Plug open lines and connections immediately with appropriate protective caps.

Place parts that have been removed on a clean surface and cover them. Do not use fluffy cloths!

Only install clean parts: Only unpack replacement parts immediately prior to installation. Do not use parts that have been stored unpackaged (e.g. in tool boxes etc.).

When the system is open: Do not work with compressed air. Do not move vehicle unless absolutely necessary.

Separated electrical connections: Protect from dirt and moisture. Connect only when dry.

Turbocharger

When working on turbocharger, carefully observe the following " 5 rules" of cleanliness:

Thoroughly clean all connections and the surrounding area before disconnecting.

Place parts that have been removed on a clean surface and cover them. Do not use fluffy cloths!

Carefully cover over opened components or seal, if repairs are not performed immediately.

Only install clean components: Only unpack replacement parts immediately prior to installation. Do not use parts that have been stored loose (e.g. in tool boxes etc.).

When the system is open: Avoid working with compressed air if possible. Do not move vehicle unless absolutely necessary.