High Beam Bulb, From MY 2007

High Beam Bulb, from MY 2007

Removing





- Switch off ignition and remove ignition key.

- Turn light switch into "0" position.

- Remove screws - arrows -.

- Disengage Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80) - item 1 - at air duct.

- Remove air duct - 2 -.

- Release spring clip - arrow - and remove high beam/parking lamp housing cover from headlamp housing.





- Remove bulb - 1 - from spring clips - arrows -.





- Disconnect harness connector - 2 - at high beam bulb.

Installing

Install in reverse order of removal, observing the following:

- Insert bulb in housing, taking care not to touch glass bulb with bare hands.

- Place bulb on lower spring clip.

- Press bulb in housing over upper spring clamp resistance.

- Re-connect harness connector and close housing cover.

- Secure housing cover using wire clamp.