Headlight Beam Adjusting Motor, Repair Kit

Headlight Beam Adjusting Motor, Repair Kit

Special tools, testers and auxiliary items required

• Protective eyewear

• Protective gloves

• Faulty headlamp beam adjusting motors can be replaced by installing repair kit.

• Completely replacing the headlamp is not necessary.

Removing





- Remove headlamp, refer to => [ Headlamps, from MY 2007 ] Headlamps, From MY 2007.

- Cut cover - 2 - along perforation using a sturdy box cutter - 1 -.

- Slide adjusting axle ball head down and off ball head mount by tipping adjusting motor.

- Disconnect electrical connector and remove headlamp beam adjusting motor with cover cut off.

- Remove screws and remove headlamp beam adjusting motor from cover.

Installing





- Release retainer tabs - arrow - and remove housing cover from headlamp housing.

- Install new headlamp beam adjusting motor - 1 - with previous screws - 2 - on cover - 4 - from repair kit.





- Connect electrical connector - 3 - with headlamp beam adjusting motor.

- Start by inserting ball end of positioning stem from underneath in reflector socket. To do so, pull reflector to rear.

- Fasten cover with headlamp beam adjusting motor to headlamp housing using screws - 5 - from repair kit.

- Install headlamp.

Tightening Specifications