Rear Bumper Cover, Audi RS4

Rear Bumper Cover, Audi RS4

Removing






- Remove tail lights.

- Disconnect the central connector - 1 -.

- Press the grommet - 2 - outward.

- Remove cover.






- Remove the nut - 2 -.

- Remove the bolts - 1 - on the lower bumper cover section.

- Remove the bolts - arrows - and press the wheel housing liner - 1 - to the side.






- Remove the screw - 2 -.

- Remove the retaining pin - 2 - upward - arrow A -.






- Remove the left and right bumper cover side pieces on the side panel - arrow B -.

- Remove the bumper cover - 1 -. When doing this, the wiring harness must also be guided out from the vehicle body pass through.

Installing

• Tightening specifications, refer to => [ Rear Bumper Cover Assembly Overview, Audi RS4 ] Rear Bumper Cover Assembly Overview, Audi RS4.

Install in reverse order of removal. Note the following:

- Install tail lights.

• With lane change assistance: If the bumper cover was removed, the lane change assistance must be calibrated.