Part 1

Rear Lid, Adjusting

Special tools, testers and auxiliary items required

• Adjustment Gauge (3371)

Gap Dimensions





Check the gap dimensions with the (3371).

• - A - = 4.5 mm ± 0.5 mm

• - B - = 4.5 mm ±0.5 mm

• - C - = 4.5 mm ±0.5 mm

Height Adjustment






- The lid front height can be adjusted by loosening the nut and sliding it in the direction of the - arrow -.

- With the hinge installed, the rear shelf must be removed.

- With the rear shelf installed, disengage the spring on the hinge.

- Remove the hinge under the rear shelf, loosen the nut on the hinge and slide it accordingly.

- After adjusting, tighten the nut on the hinge to 20 Nm.

- Install the hinge and engage the spring and gas-filled strut, if necessary.

- The rear height can be adjusted by sliding the striker pin - 1 -.






- Loosen the nut - 2 -, slide it accordingly and tighten the nuts to the specification.