Allroad Molding and Trim

Sill Panel Trim Assembly Overview

Special tools, testers and auxiliary items required

• Roller (3356)

• Adjustment gauge (3371)

• Template (T40038 /8)

• The attached trim can only be replaced, removal without destruction is not possible.

• Remove adhesive residue on body if necessary.

• The adhesive surfaces must free of dust and grease. Clean with cleaning solution (D 009 401 04).

• Apply some bonding agent (D 355 205 A2) on the adhesive surface on the body side using the applicator (D 009 500 25) and let it dry for 10 minutes.

• When installing, the trim must be applied according to the contours. It is not possible to make corrections later.

• Press the covers with the roller (3356) after installation.

Side Member Trim Panel, Removing and Installing






1 Sill panel cover

- Remove the lower bolts when removing

- Starting at the front, remove the sill panel trim from bottom to top from the Velcro fastener for the securing strip.

- Install the trim on the securing strip starting at the top when installing.

- Press in the upper trim on the Velcro fastener and secure it with the lower bolts.

• If the same sill panel trim is installed again, the adhesive tape must be replaced.

2 Clip

3 Bolt

• 1.5 Nm

4 Adhesive tape

• Delivery casing for new parts

5 Velcro fastener

Removing and Installing securing strip






1 Securing strip

- Remove the nut and remove the securing strip.

- Remove the protective film from the adhesive tape and position and press in the securing strip according to the contour, before installing.

2 Bolts

3 Adhesive tape

4 Nut

• 2 Nm

Remove the front sill panel trim






- For removal, remove the bolts - 2 - and the front trim - 1 -.

- Tighten the screw to 2.5 Nm.

• 1 front sill panel trim

• 2 screw

• 3 expanding clip