Floor Covering

Floor Covering

Removing

- Remove the front seat:

• Standard seat and Sport seat (manual), refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

• Standard and Sport Power Seat, Comfort Seat and Super Sport Seat, refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

- Remove the seat bench. Refer to => [ Bench Seat ] Bench Seat.

- Remove the driver side instrument panel cover. Refer to => [ Instrument Panel Cover, Driver Side ] Instrument Panel Cover, Driver Side.

- Remove center console. Refer to => [ Center Console ] Center Console.

- Remove the center console bracket and lower the shift mechanism. Refer to => [ Center Console Bracket ] Center Console Bracket.

- Remove the rear center console vent on the center tunnel.

- Remove the front sill panel trim. Refer to => [ Front Sill Panel Trim ] Front Sill Panel Trim.

- Remove the rear sill panel trim. Refer to => [ Rear Sill Panel Trim ] Rear Sill Panel Trim.

- Remove the B-pillar lower trim piece. Refer to => [ B-Pillar Lower Trim ] B-Pillar Lower Trim.

- Disengage the floor covering at brackets - 1 - and - 2 -.






- Pull the floor covering - 3 - back.

• Make sure the floor covering does not tear at the openings.

- Fold the floor covering lengthwise and remove it through a door.

Installing

- Fold the floor covering lengthwise and lay it in the vehicle.

- First slide the floor covering forward until the air duct and shift mechanism openings are aligned.

- Then attach the floor covering at brackets - 1 - and - 2 -.

Further installation is performed in the reverse order of removal.