Operation CHARM: Car repair manuals for everyone.

Ribbed Belt Drive Assembly Overview






Ribbed Belt Drive Assembly Overview






1 Ribbed belt

Check for wear

Before removing, mark the direction of rotation using chalk or a felt-tip pen.

Removing and installing, refer to => [ Ribbed Belt ] Ribbed Belt

Do not kink

When installing, make sure it is seated correctly on the ribbed belt pulleys

2 Bolt

Replace

20 Nm plus an additional 90° turn

3 Generator

4 Bolt

5 Idler roller cover

6 Idler roller for ribbed belt

40 Nm

7 Bolt

Tightening specifications, refer to => [ Coolant Pump, Thermostat and Connecting Piece Assembly Overview ] Coolant Pump, Thermostat and Connecting Piece Assembly Overview

8 Ribbed belt pulley for coolant pump

9 Bolt

Tightening specifications, refer to => [ Coolant Pump, Thermostat and Connecting Piece Assembly Overview ] Coolant Pump, Thermostat and Connecting Piece Assembly Overview

10 Coolant pump

Removing and installing, refer to => [ Coolant Pump ] Coolant Pump

11 Bolt

12 Bolt

13 Bracket for power steering pump

14 Slide bushing

15 Bolt

16 Bolt

17 Power-steering pump

18 Power steering pump ribbed belt pulley

19 Bolt

20 Tensioning element for ribbed belt

Removing and installing, refer to => [ Ribbed Belt Tensioner ] Service and Repair

40 Nm

21 Bracket for air conditioning compressor

Be careful of the alignment bushings when installing

22 Bolt

20 Nm

23 A/C Compressor

Do not remove or disconnect refrigerant lines

Be careful of the alignment sleeves - 25 - when installing

24 Bolt

25 Alignment bushing

2 pieces

26 Tensioner cover

27 Vibration damper

With ribbed belt pulley

Installation is only possible in one position because of the offset holes

Removing and installing, refer to => [ Vibration Damper with Ribbed Belt Pulley ] Service and Repair

Ribbed belt pulley side sealing flange - tightening specifications and sequence





- Tighten the bolts - arrows - in a diagonal sequence in stages to 9 Nm.