Tire Pressure Monitoring System (PR7K8) Control Module (J502)

Tire Pressure Monitoring System (PR7K8) Control Module (J502)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

Removing

The tire pressure monitoring control module is located in the right front footwell under the instrument panel.

Before removing the tire pressure monitoring control module , perform Guided Fault Finding under "replace control module".

- Remove the glove compartment.

- Remove the sill panel strip.

- Remove the locking mechanisms - A arrows - and the cover - arrow B -.






- Remove the bolt - 1 - and the vent - 2 -.






- Remove the cover - arrow - and the pollen filter.






• Make sure the carpet does not tear when handling it.

- Carefully lay the carpet aside with the help of a second technician.

- Move the insulating mat - arrow - up.






- Release and remove the connector - 3 -.






- Remove the nuts - 1 - and remove the tire pressure monitoring control module - 1 - upward.

Installing






Install in reverse order of removal. Note the following:

- If the center console was pulled out of the instrument panel when pulling the carpet back, insert the center console with the pins - 1 - in the instrument panel - 2 -.

- Tighten the nuts - 1 - to 2 Nm.

- The system must be coded if the tire pressure monitoring control module is replaced => [ Tire Pressure Monitoring System (PR7K8), Using the System ] Tire Pressure Monitoring System (PR7K8), Using the System use vehicle diagnostic tester.