Heated Oxygen Sensor 2 (G108) In Front of Bank 2 Left Catalytic Converter

Heated Oxygen Sensor 2 (G108) in Front of Bank 2 Left Catalytic Converter

Special tools, testers and auxiliary items required

• Ring Spanner 7-Piece Set (3337)

Removing

- Pull rear engine cover off - arrows -.






- Remove the coolant reservoir - arrows -.






- Disconnect the electrical connector to the engine coolant level warning switch (F66) on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses - 1 and 2 - and - 3 - attached.

- Disconnect the electrical connector - 2 - for the heated oxygen sensor 2.






- Remove the heated oxygen sensor 2 - 1 - using a tool from the (3337).






• The installation location is shown with the engine removed.

Installing

Installation is performed in the reverse order of removal, noting the following:

• Tightening specification, refer to => [ Oxygen Sensors Overview ] Oxygen Sensors Overview

• Coat new oxygen sensors with an assembly paste.

• When installing the previous oxygen sensor, coat the thread with hot bolt paste. Refer to the electronic parts catalog ETKA.

• Assembly paste or hot bolt paste must not enter the slots on the oxygen sensor body.

• Always install the oxygen sensor wire in the same location so it does not come into contact with the exhaust pipe.

• During installation, all cable ties must be installed at the same location.