Rear Lid

Rear Lid






1 Gas strut

• Noise insulation component must be installed on the body side.

2 Hood hinge

• Removing, refer to => [ Rear Lid Hinge ] Rear Lid Hinge

3 Motor in rear lid control module (V375)

4 Rear lid

• Removing

• Remove rear lid trim.

• Disconnect the connectors and remove the hose for the rear window washer.

• Remove rear lid motors on vehicles equipped with a power rear lid release, refer to => [ Rear Lid Motor Overview ] Rear Lid Motor Overview.

• Second person is required to support and lift hood.

• Remove gas-filled struts from rear lid.

• Remove the bolts on the left and right lid hinges.

• Lift off the rear lid.

5 Cover

6 Rear lid latch

• Removing=> [ Rear Lid Lock ] Rear Lid Lock

7 Cover

8 Nuts

• 21 Nm

9 Seal

• Removing and installing, refer to => [ Rear Lid Seal ] Rear Lid Seal

10 Adjusting buffer

• Adjusting, refer to => [ Adjustment Buffer Installation
Position ] Rear Lid, Adjusting

11 Screws

• 8 Nm

12 Hood catch

• Note different versions.

13 Nut

• 21 Nm

14 Stop

15 Bolt

• 8 Nm