Electro-Mechanical Steering Gear With Tie Rods Overview

Electro-Mechanical Steering Gear with Tie Rods Overview






1 Electro-Mechanical Steering Gear with Tie Rods

• With Power Steering Control Module (J500)

• Removing and installing, refer to => [ Electro-Mechanical Steering Gear ] Electro-Mechanical Steering Gear

• Servicing, refer to => [ Electro-Mechanical Steering Gear Overview ] Electro-Mechanical Steering Gear Overview

• Different versions, refer to the Parts Catalog

A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.

A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and installing on a new steering gear.

A replacement steering gear comes with the bonded heat shield mat.

2 Bolt

• 80 Nm + 180° turn

• Always replace if removed.

3 Subframe

4 Nut

• Pushed into the subframe

• Always replace if removed.

5 Steering Intermediate Shaft

6 Bolt

• Tightening specification - item 18 - => [ (Item 18) Bolt ] Steering Column Overview

7 Wheel Bearing Housing

8 Nut

• 100 Nm

• Always replace if removed.