Selector Lever Cable, Bringing Into Basic Setting

Selector Lever Cable, Bringing into Basic Setting

Special tools, testers and auxiliary items required

• Pry Lever - Rmv Outside Mirror (80 - 200)

• Trim Removal Wedge (3409)

• Vehicle Diagnostic Tester (VAS 5051B)

• Socket and Key (T40031)

Procedure






• Guided fault finding with the vehicle diagnostic tester is completed and all faults have been corrected.

- Select the following menu entries on the vehicle diagnostic tester in Function/Component Selection Guided Fault Finding :

• Drive

• 0B6-Transmission

• 01-On Board Diagnostic (OBD) Capable Systems

• 02-Transmission Electronics

• 02-Transmission Electronics Functions

• 02-Read Measure Value Block

- Select the measured value gear on the vehicle diagnostic tester.

- Compare the following displays:

• Measured value gear on the vehicle diagnostic tester

• Selector lever position

• Selector lever transmission range position display unit (Y26) on the shift mechanism

• Transmission range display (Y6) in the instrument cluster

Conditions:

• The displays must match

If the displays do not match:

- Adjust selector lever cable. Refer to => [ Selector Lever Cable, Adjusting ] Adjustments

If the individual displays cannot be reached by adjusting the selector lever cable:

Selector Lever Cable, Bringing into Basic Setting:

• Tightening specification, refer to => [ Selector Lever Cable Overview ] Description and Operation.

- Pry the selector lever boot frame - A - out of the center console - arrows - using the (3409).






- Move the selector lever into D.

- Loosen the screw on the selector lever cable through the opening - arrow - in the selector mechanism one turn using the (T40031).






• Only loosen the clamping screw - do not remove it.

• The clamping screw is only accessible when the selector lever is in D.

• The selector lever must remain in D when the clamping screw is loose.

- Remove the ball socket - 1 - on the selector lever cable from the selector shaft lever using the (80 - 200).






• Do not bend or kink the selector lever cable.

• Lubricate the cable eye and the ball socket on the selector lever cable with polycarbamide grease (G 052 142 A2) before installing.

• Ignore - 2 -.

- Push the selector shaft lever - 1 - on the transmission all the way back - arrow -, until the parking lock engages.






• When parking lock is engaged, it must not be possible to turn both front wheels in one direction at the same time.

- Press the selector shaft lever forward three detents so the transmission is in D.

- Make sure the selector lever inside the vehicle is also in D.

- Select the 02 - Transmission Electronics and then Read Measure Value Block on the vehicle diagnostic tester in Guided Fault Finding

- Select measured value gear on the vehicle diagnostic tester.

- Compare the following displays:

• Measured value gear on the vehicle diagnostic tester

• Selector lever position

• Selector lever transmission range position display unit (Y26) on the shift mechanism

• Transmission range display (Y6) in the instrument cluster

Conditions:

• The displays must match

- Carefully press the selector lever cable ball socket - 1 - in this position onto the selector shaft lever.






• Do not bend selector shaft lever when pressing on, otherwise shift mechanism can no longer be adjusted exactly.

• Ignore - 2 -.

- Adjust the selector lever cable. Refer to => [ Selector Lever Cable, Adjusting ] Adjustments.

- Selector mechanism, checking, refer to => [ Selector Mechanism, Checking ] Selector Mechanism, Checking.