Front Door Window Motor: Service and Repair

Window Regulator Motor






1 Connector

- Disconnect the connector on the door control module.

2 Window regulator motor

• The window regulator motor can be removed or installed with the motor or door window in any position.

• Removing

- Remove the door trim panel.

- Remove the screws - 6 - and remove the window regulator motor from the window regulator.

• Installing

• Tightening specifications, refer to => [ Window Regulator Motor and Window Regulator Assembly Overview ] Window Regulator Motor and Window Regulator Assembly Overview.

Install in reverse order of removal. Note the following:

• The clips- arrow - for the window regulator threaded pins must be latched into the inner door panel.

- Mount the window regulator motor on the threaded pins and tighten the screws - 6 -.

• With the window regulator motor switches connected, switch the ignition on and run the door windows up to the stop.

• Continue holding the window regulator switch for approximately 2 seconds so the basic setting and one-touch up/down function are activated.

3 Threaded pins

4 Window Regulator

5 Bolt

• 3.5 Nm