Left Engine Mount

Left Engine Mount

Special tools, testers and auxiliary items required

• Engine support bridge (10 - 222 A)

• Engine Support Basic Set (T40091)

• Engine Support Supplement Set (T40093)

Removing

• During installation, all cable ties must be re-installed at the same location.

- Pull rear engine cover - arrows - off.





- Remove rubber seal - 1 - and remove plenum chamber cover - 2 -.





- Secure Adapter (10 - 222 A /4) with connector (T40091/3) and supports (T40093/1) and (T40093/2) to suspension strut towers.





• Support for left and right side of vehicle is marked.

- Install additional Engine Support Bridge (10 - 222 A) parts as shown in illustration. Position supports (T40093/3) on long member notches.





- Engage Hook (10 - 222 A /10) in left engine lifting eye.

- Tension engine with spindle.

- Remove sound insulation by loosening securing pieces - 1, 2, arrow -.





Vehicles with auxiliary heater:

- Remove left front wheel.

- Remove left front wheel housing liner.

- Remove bolt - arrow - for corrugated exhaust pipe.





- Loosen nut - A - on clamp for corrugated exhaust pipe.





- Remove bolt - B - and remove muffler with corrugated exhaust pipe.

All:

- Remove bolts - 1 and 2 - for left and right stabilizer bar mount.





- Slightly lower stabilizer bar.

- Remove nut - 3 -.





- Remove bolts - 1 and 2 - and remove left engine mount plate.

- Disconnect electrical harness connector - arrow - at left engine mount.





- Remove bolts - 1, 2, 3 - and remove engine support from engine mount.

- Remove nut - arrow - and remove engine mount from engine support.





Installing

• Tightening Specifications => [ Assembly Mount, Overview ] Assembly Mount, Overview.

Installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to torque.

• During installation, all cable ties must be re-installed at the same location.

- Install stabilizer bar.