Antenna Amplifier, From 1 September 2008

Radio System

Antenna Amplifier, from 1 September 2008

• The Antenna Amplifier (R24)/Antenna Amplifier 2 (R111) are located behind the roof end trim.

• Removal and installation of antenna amplifier and antenna amplifier 2 are the same.

- Switch off all electrical consumers.

- Remove the key.

Removing

- Remove the roof end trim.

- Remove connector for antenna wires - 3 - and - 4 -.





- Disconnect ground (GND) connection - 2 - (9 Nm).

- Disengage retaining clips - arrows - on both sides and remove antenna amplifier - 1 -.

Installing

- Install in reverse order.