Voice Recognition System

Voice Recognition System

Speech Input Control Module

- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine.

Use the Vehicle Diagnosis, Testing and Information System (VAS 5051) to do so.

CAUTION!
• Switch off all electrical components.

• Switch off ignition and remove ignition key.

Removing

- Remove Radio (R) => [ Radio ] Radio System.

- Open cover - 2 - of Radio (R) and fold it downward - arrow -.





- Carefully pull Speech Input Control Module (J507) - 1 - out of Radio (R) in - direction of arrow -.

Installing

- Install in reverse order.

- Make sure that harness connector between Speech Input Control Module (J507) and Radio (R) engages correctly in Radio (R).

Perform the following function test:

- Switch on Radio (R).

- Press PTT button briefly on multi-function steering wheel.

A "ping" tone sounds, the speech dialog system is active.

- Speak the command "Help"

Since the Radio (R) is active, the speech dialog system responds with "Radio commands are...".

Can be switched to other sources, depending on equipment:

- If a telephone is installed, say "Telephone".

The speech dialog system changes to Telephone mode.

- Press the PPT button for approx. 1 second.

The speech dialog system responds with "Cancel" and is deactivated.