Rear Vents, 2-Zone A/C System

Center Console without Extension

Rear Vents, 2-Zone A/C System

Removing

Removal is depicted at a rear vent, 2-zone A/C system without seat potentiometer.

Removal with seat potentiometer is performed analogously.

- Remove bolts - 1 - (Qty. 2).





- Pull rear air vents, 2-zone A/C system - 2 - out of center console - 3 -.

- Disconnect electrical connectors.

Rear Storage Compartment, Removing





- Switch off ignition.

- Remove the rear storage compartment - 1 - from the center console - 2 -.

3 Rear center console panel
4 Rear air vents, 2-zone A/C system
5 Rear cigarette lighter

Rear Center Console Trim, Removing

- Unclip rear center console panel - 1 -.





2 Rear air vents, 2-zone A/C system

Cigarette Lighter, Removing

- Rotate cigarette lighter - 1 - in -direction of arrow- until it stops.





- Pull cigarette lighter out of mount in rear air vents.

Installing

Installation is reverse of removal. Observe the following when doing so:

• Follow the installation sequence when installing cigarette lighter and rear center console panel.

- Connect electrical harness connector.

- Insert cigarette lighter with roll pin - 1 - into mount - 2 - in rear air vent.





- Rotate cigarette lighter clockwise until it stops.

- Clip rear center console panel into rear air vents, 2-zone A/C system.

Tightening Specifications

Rear air vents, 2-zone A/C system: 4 Nm