Right Trim Molding With Switch Strip

Instrument Panel

Right Trim Molding with Switch Strip

Removing





- Open coin tray.

- Slide coin tray panel toward the left out of catch - arrow - and remove.

- Open glove compartment.





- Carefully disengage decorative panel with switch strip - 1 - - starting above the glove compartment - from instrument panel using trim removal wedge (3409).

- Pull off decorative panel with switch strip in - direction of arrow -.

• Be especially careful when releasing clip on the driver's side end of decorative panel.

- Disconnect electrical connector.

Installing

Installation is reverse of removal, noting the following:

- When inserting decorative panel - 1 - with switch strip, make sure that both catches in panel center are inserted between instrument panel and screen housing - arrows -.