Oil Pump and Lower Section of Oil Pan Assembly Overview
Oil Pump and Lower Section of Oil Pan Assembly Overview
1 Bolt
• 9 Nm
2 Lower oil pan section
• Removing and installing, refer to => [ Oil Pan Lower Section ] Oil Pan Lower Section
3 Bolt
• 9 Nm
4 Oil pipe
5 Gasket
• Replace
6 O-ring
• Replace
7 Bolt
• 9 Nm
8 Bolt
• 9 Nm
9 Oil check valve housing
10 Gasket
• Replace
11 Oil check valve
12 O-ring
• Replace
13 Oil pipe
14 Bolt
• 9 Nm
15 O-ring
• Replace
16 Driveshaft for coolant pump
17 Fitting sleeves
• 2 pieces
18 Oil pump
• Do not disassemble
• With relief valve approximately 5.5 bar
• Removing and installing, refer to => [ Oil Pump ] Oil Pump
19 Driveshaft for oil pump
20 Bolt
• Replace
• 8 Nm plus an additional 90° (1/4) turn.
21 Gasket
• Replace
22 Intake tube
• For oil pump
23 Bolt
• 9 Nm
24 Oil strainer
• Clean
25 Oil baffle
26 Bolt
• 9 Nm
27 Seal
• Replace
28 Oil Level Thermal Sensor (G266)
29 Bolt
• 9 Nm
30 Oil drain plug
• 25 Nm
31 Seal
• Replace
Lower section of oil pan, tightening sequence
- Tighten bolts in 3 stages as follows:
- Tighten bolts by hand in a diagonal sequence.
- Pre-tighten all the bolts in a diagonal sequence to 5 Nm.
- Tighten the bolts in a diagonal sequence to 9 Nm.