Left and Right Engine Mounts

Left and Right Engine Mounts

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Adapter (10 - 222 A /21)

• Engine Support Supplement Set (T40093)

Removing

- Pull rear engine cover off - arrows -.





- Remove rubber seal - 1 - and remove plenum chamber covers - 2 and 3 -.





- Remove tower brace rear bolts - 3 -.





- Secure Engine Support Bridge (10 - 222 A /21) with Adapter (10 - 222 A /4) at suspension strut towers.

• Support for left and right side of vehicle is marked.

• The middle contact point - 2 - of the support is placed on the tower brace front bolts.

• The Adapters (10 - 222 A /21) are secured with the tower brace rear bolts - 3 -.

• The knurled thumb screw - 1 - must be turned downward far enough so that the contact plate rests on the strut tower.

- Install Adapter (10 - 222 A /4) with adapters (T40093/6) on adapters (10 - 222 A /21).





- Secure Spindles (10 - 222 A /11) at engine lifting eyes.

- Lightly tension engine with engine support bridge spindles.

- Remove front noise insulation by loosening fasteners - 1 -.





• Ignore items - 2, 3 and 4 -.

- Remove left and right stabilizer bar mount bolts - 1 and 2 -.





- Slightly lower stabilizer bar.

- Remove bolts - 3 and 4 -.





• Ignore items - 1 and 2 -.

- Remove engine bracket at left and right - arrows -.





- Remove engine carrier.

Left engine mount:

- Disconnect electrical connector - 1 - on engine mount.





- Remove bolts - arrows - and remove engine support with engine mount.

Right engine mount:

- Free up secondary air injection (AIR) air guide hose - 1 - on ATF cooler bracket.





- Remove bolts - arrows - and remove ATF cooler.

- Secure ATF cooler with connected coolant hoses to engine.

- Disconnect electrical harness connector - 2 - at right engine mount.





- Remove electrical wiring bracket - 1 - from right engine support.

- Remove bolts - arrows - and remove engine support with engine mount.

Continued for both sides:

- Remove bolt - arrow - and remove engine mount from engine support.





Installing

• Tightening specifications. Refer to => [ Subframe Mount Assembly Overview ] Subframe Mount Assembly Overview.

Installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to torque.

• During installation, all cable ties must be re-installed at the same location.

- Install subframe.

- Install stabilizer bar.

- Install ATF cooler.

- Install dome brace.