Operation CHARM: Car repair manuals for everyone.

Cooler Thermostat






Cooler Thermostat

Removing

Install all cable ties that were loosened or cut off during removal in the same positions.

- Remove cooler => [ Cooler ] Cooler.

- Pull off thermostat rotary handle - 1 -.





Use universal pliers if it is difficult to pull off the rotary handle.

Wrap ends of pliers to prevent damage to rotary handle.

- Remove nut -1- and bolts - arrows -.





- Remove panel - 2 - with cooler lid.

- Disconnect the electrical connectors -1 through 4-.





- Disconnect electrical harness connectors - 1 - and -4-.





- Carefully pull capillary tube - 3 - out of cooler housing - arrow - and remove thermostat - 2 -.

Installing

Installation is reverse of removal, noting the following:

Ensure that capillary tube is not kinked or damaged.

Thermostat must be replaced if capillary tube is kinked or damaged.

All cable ties should be re-installed in same positions.

- Slide capillary tube - 3 - approximately 66 cm far into drilling.





- Ensure that locating tab on thermostat - 2 - engages into drilling on panel - 1 - - arrows -.

Tightening torque:s