Sunroof / Moonroof: Testing and Inspection

Sunroof Adaptation

• Whenever a glass panel, a motor, the slotted guide rail or the sun shade is removed, it is necessary to perform an adaptation for the appropriate drive.

• If new motors have been installed, then the adaptation process will start 10 seconds after the switch has been activated.

• Pinch protection is switched off when performing an adaptation.

Power sunroof control module (J245) adaptation

The ignition is switched on.

The sunroof regulator (E139) must be in the "sunroof closed" position.

- Pull the sunroof regulator (E139) - 1 - down - arrow - and hold it steady in this position for the entire adaptation process (about 20 seconds).





- During the adaptation process, the glass sunroof will first close and then retract by approximately 200 mm.

- Let go of the sunroof regulator (E139) after the sunroof closes again and the adaptation procedure has completed.

Roof blind control module (J394) adaptation

The ignition is switched on.

- Press the folding sunroof button 1 (E584) close sunshade - 2 - and hold it in this position for the entire adaptation process (about 20 seconds).





- During the adaptation process, the sunshade will first close and then retract by approximately 200 mm.

- Release the folding sunroof button 1 (E584) after the sunshade has closed again; the adaptation process is now complete.