Trim

Trim

Special tools, testers and auxiliary items required

• Seat Repair Stand (VAS6136)

Removing


• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnic components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Remove the front seat:

• Manual Sport seat. Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

• Power Sport seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

- Attach the front seat to the (VAS 6136). Refer to=> [ Front Seat, Installing on Seat Repair Stand ] Overhaul.

- Equipment level with storage compartment: remove the storage compartment. Refer to => [ Storage Compartment ] Storage Compartment.

- Pry the clips - arrows - (quantity: 4) out at the trim - 2 -.






- Remove the trim from the seat depth adjustment base plate - 1 -.

• Ignore - 3 -.

Installation


• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnic components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Make sure the connectors are installed all the way in and are secure.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle diagnostic tester.