Headrest Cover

Headrest Cover

Special tools, testers and auxiliary items required

• Removal Wedge (3409)


• It is only possible to replace the cover on the headrest with a leather cover. It is not possible to replace a fabric headrest cover because the cover is filled with foam and also serves as the casing for the upholstery.

• The headrest support is built into the upholstery. Both components are attached to each other and cannot be separated.

Removing






- Remove the rear headrests. Refer to => [ Headrest ] Headrest.

- Open the zipper by inserting the (3409) between the zipper and the cover.

- Tension the lower U-channel - 2 -.

- Remove the upper cover with the flat channel - 1 - out of the lower U-channel - arrows -.

• The cover must be completely open to remove the upholstery.

- Remove the cover - 3 - from the support with the upholstery.

Installation

- Install cover - 3 -.

- Position the cover and slide it correctly over the support with cushion.

- Close the zipper while installing the upper flat channel - 1 -.

- Push the edge of the cover with the flat channel into the U-channel - 3 -.

- After closing the zipper with a needle or pointed tool, line up the cover the strip.

- Make sure the cover lies on the upholstery without any wrinkles and without seam markings.

Further installation is performed in the reverse order of removal.