Exterior Mirror Turn Signal Lamps

Exterior Mirror Turn Signal Lamps

Special tools, testers and auxiliary items required

• Hook (3438)

• Protective gloves

Removing







Danger of unintended engine ignition.

Turn off the ignition and remove the ignition key from the vehicle interior for all work performed on the high voltage vehicle.

- Switch off ignition and remove ignition key.

- Remove the rearview mirror, refer to - 1 -.

- Pull the outside mirror housing - 2 - far just enough in the direction of - arrow A - until the tabs in the cover disengage.






- Using the Hook (3438) , release the left and right retaining tabs - 1 - in the direction of - arrow B - and remove the outside mirror housing from the cover.

- Press the mirror adjusting unit down and pull the exterior rearview mirror housing - 2 - upward slightly.






- Disconnect the lane change assistance warning lamp connector on the front side of the mirror adjusting unit mount, if applicable.

- Disconnect the connector - 1 - and remove the outside mirror housing.

- Remove bolt - 2 -.






- Remove the turn signal bulb housing - 3 - from the outside mirror housing - 1 - in the direction of - arrow B -, by pulling the bulb housing out of the guide in the direction of - arrow A -.

Installing






• Tightening specifications, refer to=> [ Exterior Rearview Mirror Turn Signals Overview ] Service and Repair and.

Install in reverse order of removal, observing the following:

• The entire exterior mirror turn signal must be replaced if an LED is faulty.

- Insert the tip of the turn signal in the slit in the exterior rearview mirror housing - 1 - - arrow -.

- Place the turn signal bulb housing - 3 - into the outside mirror housing; make sure the groove fits into the guide - 2 -.

- Install the rearview mirror..