Lumbar Support Adjustment Switches

Lumbar Support Adjustment Switches

Removing

- Remove trim panel - 2 -. Refer to => [ Trim ] Trim.






- Create photos or sketches of wire securing and routing.

- Disconnect the connector - 1 -.

- Remove bolts - 3 - (quantity: 2).

- Remove lumbar support adjustment switch - 4 - from trim panel - 2 -.

Installing

Install in reverse order of removal. Note the following:

- Route and secure wiring according to photos or sketches that were made.

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.


Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. Maintain personal safety when connecting the battery by staying out of airbag deployment areas, keeping a distance from belt tensioners/seat belts and ensuring no other people are in the vehicle interior at the moment when the battery is connected.

- Switch on ignition.

- Connect the battery ground cable with the ignition turned on.

- If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the => Vehicle diagnosis, testing and information system VAS 5051.

Tightening specification, refer to=> [ Lumbar Support Adjustment Switch (E176)/(E177) ] Lumbar Support Adjustment Switch (E176)/(E177).