Telephone System

Radio, Telephone, Navigation System Antenna (R52)

The GPS/GSM antenna wires are attached to the D-pillar, top right.

- Switch off all electrical consumers.

- Remove the key.

Removing

- Remove the trim from the right D-pillar.

- Lower the back end of the headliner.

- Disconnect harness connectors - 4 - and - 5 - at retainer.





- Unclip antenna wires and remove the nut - 2 - (6 Nm).

- Remove Radio, Telephone, Navigation System Antenna - 1 - upward from roof.

Installing

- Guide in antenna wires and carefully attach Radio, Telephone, Navigation System Antenna on the roof.

- Make sure that antenna wires - 3 - are inserted in the groove - arrow - of antenna base and securing nut - 2 - so that they are not pinched or crimped.





- Tighten nut - 2 - uniformly to 6 Nm.

- Make sure that the Radio, Telephone, Navigation System Antenna - 1 - is installed level on the roof.

- If necessary, secure antenna wires with adhesive tape and clip antenna wires - 4 - and - 5 - into retainer.

- Connect harness connectors.

- Perform further installation in reverse order.