Engine and Transmission, Securing to Holder

Engine and Transmission, Securing to Holder

Special tools, testers and auxiliary items required

• Lifting tackle (3033)

• Engine and transmission holder (VAS 6095) with V8 FSI engine holder (6095/1-6A)

• Shop crane (VAS 6100)

• Engine mount (3269)

• Lift arm extension for workshop crane (VAS 6101)

Procedure

• Engine/transmission assembly removed and separated on scissor lift table (VAS 6131 A) => [ Engine and Transmission, Separating ] Engine and Transmission, Separating.

• Engine secured with joint support (VAS 6131/13-7).

• Place a cloth under separating point to catch dripping hydraulic fluid.

- Remove power steering pressure line banjo bolt - 1 -.





- Remove engine bracket left and right bolts - arrows -.





• Engine carrier remains in installation location.

With 4 Zone Climate Control

- Remove rear coolant pipes from coolant hoses - arrows -.





• Ignore items - 1, 2, 3 -.

• The illustration shows location with automatic transmission.

Continuation for All

- Engage lifting tackle (3033) in engine lifting eyes and in shop crane (VAS 6100) with lift arm extension/workshop hoist (VAS 6101) as shown in illustration.





- Tension engine slightly with shop crane, do not raise.

- Remove joint support (VAS 6131/13-7) from engine.





- Raise engine from engine carrier.

Engine, Engaging at Rear

- Secure engine on engine and transmission holder (VAS 6095) as shown in illustration.





Engine, Engaging at Sides

- If engine support (3269) is to be used, remove bolts - 1 to 3 - and remove engine supports with engine bracket.





• Ignore - 4 and arrow -.

- Secure engine support (3269) to cylinder block as shown in illustration.