Flush-Bonded Rear Lid Window Overview

Flush-Bonded Rear Lid Window Overview

• Before removing side windows, disconnect all electrical wiring to connectors if necessary and secure them to center of window with adhesive tape.






1 Rear Window

2 Adhesive Sealing Material

• Note different distances to window edge.

3 Spacer

4 Adhesive Stop Profile

• Must be adhered before window adhesive, near rear window heater distributing wire.

• Place inner edge of adhesive stop profile to outer edge of distributing wire for rear window heater and press on.

• Window adhesive must not contact window heating distributing wires when installed.

5 Spacer

• No replacement part.

6 Spoiler With Top-Mounted Brake Light

• Must be removed when rear window is removed.

• Removal, refer to => [ Rear Lid Spoiler ] Service and Repair.