Wiring Harness, Removing

Wiring Harness, Removing

The replacement wiring harness is routed according to the current wiring harness.

- Remove rear lid trim..

- Remove the spoiler.

- Remove the headliner..

- To make process easier, create photos or sketches of wiring harness routing.

- Especially observe the specified fasteners.

- Disconnect windshield washer system hose connection - 1 -.





Washer fluid hose may still be filled with fluid. Have a container nearby.

- Unclip wiring harness - 2 - from retainers - arrows -.

- Continue unclip wiring harness - 2 - accordingly on rear lid - arrows -.





- Loosen seal to spoiler - 1 -.

- Disconnect the connectors - 1 - from the Antenna Amplifier 2 (R111) and thread wires with seal - 2 - inward.





- Disconnect the connectors - 2 - and - 3 - on Antenna Amplifier 3 (R112) - item 4 - unclip wiring harness - 1 -.





- Unclip the wiring harness - 1 - at attachment points - arrows - as far as tab on Motor in rear lid control module 2 (V376) - item 2 -.





- Disconnect the wiring harness - 1 - after tab on branch - arrow -.





Washer fluid hose may still be filled with fluid. Have a container nearby.

Installing the replacement wiring harness, refer to => [ Wiring Harness, Installing ] Wiring Harness, Installing.